Highway Guard Rail Roll Forming Machine With Two Waves And Punching Holes
1. The main specifications of the guardrail forming machine
--.material into the leading wheel set to open.
--.Level for the next three to four roll, forming shaft diameter Φ80mm(material 45# by quenching), roll material is GCR15, quenching to HRC58°-62°, hard chromium plated, suppression of thickness 2.5m-3.0m.
--.punching:adopt hydraulic punching(material Cr12 model steel quenching, can be adjusted left and right, front and back)
--.cut off hydraulic shear(material Cr12 quenching HRC60-62)
--.Total power:30KW
--.Transmission: chain drive, 2-inch single-row chain
--.Coil width: 482mm
--.Hydraulic motor power: 22KW, pression: 20Mpa
--.Unit with frequency control: 5m-12m/min
--.Computer adopt Delta PLC
--.Equipment dimension: 10m*1.2m*1.5m
2. Components of the machine
Highway Guardrail Roll Forming Line is consist of 5T passive decoiler,transmission device,leveling device,3 units pre-punching device,roller forming system,post to cut after forming,Computer control cabinet,and finished support table.
3. Training and Installation
1) We offer installation service local in paid, reasonable charge.
2) QT test is welcome and professional.
3) Manual and using guide is optional.
4. Certification and after service
1). Match the technology standard, ISO producing certification
2) CE certification
3) 12 months warranty since the delivery. Board.
5. Our advantage:
1). Short delivery period.
2). Effective communication
3). Interface customized.
6. Highway Guard Rail Roll Forming Machine With Two Waves And Punching Holes process flow as below
